STEERING CONTROL ECU(for LHD) INSTALLATION

PROCEDURE

1. INSTALL STEERING CONTROL ECU

   

   *1	Nut
   *2	Bolt

   
   

   1. Install the steering control ECU to the junction block with the bolt and nut.

      Torque:

      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

2. INSTALL STEERING CONTROL ECU WITH JUNCTION BLOCK

   

   *1	Front Side:
   *2	Rear Side:
   *3	Nut
   *4	Bolt

   
   

   1. Front side:

      
      

      1. Connect the 5 connectors.

   2. Rear side:

      
      

      1. Install the steering control ECU with junction block with the bolt and 2 nuts.

         Torque:

         8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

      2. Attach the 2 clamps.

      3. Connect the 7 connectors.

3. INSTALL LOWER INSTRUMENT PANEL (w/o Driver Side Knee Airbag)

   Click here

4. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY (w/ Driver Side Knee Airbag)

   Click here

5. INSTALL NO. 1 SWITCH HOLE BASE

   Click here

6. INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

   Click here

7. INSTALL COWL SIDE TRIM BOARD LH

   Click here

8. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Floor Under Cover)

   Click here

9. INSTALL FRONT DOOR SCUFF PLATE LH

   Click here

10. INSTALL NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH

    Click here

11. INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH

    Click here

12. INSTALL INSTRUMENT SIDE PANEL LH

    Click here

13. INSTALL LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

    Click here

14. INSTALL LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH

    Click here

15. INSTALL NO. 1 INSTRUMENT PANEL FINISH PANEL CUSHION

    Click here

16. INSTALL LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH

    Click here

17. INSTALL NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION

    Click here

18. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

19. PERFORM VARIABLE GEAR RATIO STEERING SYSTEM CALIBRATION

    Click here