STEERING CONTROL ECU(for LHD) REMOVAL

PROCEDURE


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note


    • After the engine switch is turned off, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the engine switch off, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  2. REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY (w/ Driver Side Knee Airbag)

    Click here

  3. REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY (w/o Driver Side Knee Airbag)

    Click here

  4. REMOVE NO. 1 SWITCH HOLE BASE

    Click here

  5. REMOVE STEERING CONTROL ECU WITH JUNCTION BLOCK


    1. B001YPY

      Disconnect the connectors and wire harness clamp.

  6. REMOVE STEERING CONTROL ECU


    1. B001YY9

      Remove the 2 bolts, 2 claws and steering control ECU from the junction block.