STEERING ACTUATOR INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. HANDLING PRECAUTIONS FOR STEERING ACTUATOR ASSEMBLY

    Note


    • Be careful that the No. 2 seal lip or boot does not turn outward while carrying or installing the steering actuator assembly. If installing a new steering actuator assembly, make sure that the spiral center lock pin is securely inserted.

    • Do not use the steering actuator assembly if it has been dropped.

      B001Z4WE05
      *1 Spiral Case
      *2 Boot
      *3 No. 2 Seal Lip
      *4 Actuator Clamp (Not tighten at first)

  2. INSTALL STEERING ACTUATOR ASSEMBLY


    1. Make sure that the power steering link assembly is centered.

    2. B001YT0E03
      *1 White Line
      *2 Center Lock Pin

      Install the steering actuator assembly.


      1. If installing a new steering actuator assembly:

        Install the steering actuator assembly with the white paint on the upper surface of the spiral case facing down.

        Note

        Do not pull out the center lock pin.

      2. B001XPZE04
        *1 Sliding Yoke
        *2 Slit
        *3 White Line
        *4 Alignment Mark

        If reinstalling the removed steering actuator assembly:


        1. Slowly turn the spiral case clockwise until it locks.

        2. Turn the spiral case two turns counterclockwise from the lock position.

        3. Align the slit of the sliding yoke with the alignment mark (▲).

        4. Install the steering actuator assembly with the white paint on the upper surface of the spiral case facing down.

    3. B001X2QE06
      *1 Matchmark

      Align the matchmarks on the No. 2 steering intermediate shaft and steering actuator.

      Note


      • Do not fold back the boot part of the steering hole cover or turn it excessively. If it is turned excessively, return it to its original position.

      • Do not turn the actuator body and the spiral case.

      Tech Tips

      Install the steering actuator from the inside of the vehicle.

    4. Install the bolt.

      Torque:
      35 N*m  { 357 kgf*cm, 26 ft.*lbf }
    5. B001W6X

      Using needle nose pliers, lock the clamp to the steering column hole cover to install it.

      Note

      Be careful when performing the operation as the clamp may not lock if the claws of the clamp are deformed.

    6. B001WK5

      Move the lock in the direction of the arrow and connect the steering actuator connector.

      Tech Tips

      When a new actuator is installed, remove the center lock pin.

    7. Connect the connector.

  3. INSTALL STEERING COLUMN ASSEMBLY

    Click here

  4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note


    • Reset the AUTO TILT AWAY function setting to the previous condition by changing the customize parameter Click here.

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  5. INSPECT SRS WARNING LIGHT

    Click here.

  6. PERFORM VARIABLE GEAR RATIO STEERING SYSTEM CALIBRATION

    Click here.