POWER STEERING ECU(w/ Variable Flow Control Solenoid Valve) REMOVAL

CAUTION / NOTICE / HINT

PROCEDURE


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL (for LHD)

    Click here

  4. REMOVE NO. 1 SWITCH HOLE BASE (for RHD)

    Click here

  5. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (for RHD)

    Click here

  6. REMOVE POWER STEERING ECU ASSEMBLY


    1. for LHD:


      1. B00207L

        Remove the bolt, nut and junction block.

      2. Disconnect the connectors.

      3. B001W15

        Remove the bolt, claw and power steering ECU assembly.

    2. for RHD:


      1. Remove the bolt and 2 nuts.

        B001YLN

      2. Disconnect the connectors and detach the wire harness clamp from the junction block.

      3. B001XVT

        Remove the bolt and power steering ECU assembly from the junction block.