VANE PUMP(for 1VD-FTV with DPF) REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE UPPER RADIATOR SUPPORT SEAL

    Click here

  4. REMOVE FRONT FENDER APRON TRIM PACKING A

    Click here

  5. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

    Click here

  6. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

    Click here

  7. REMOVE NO. 1 AIR CLEANER HOSE

    Click here

  8. REMOVE INTAKE AIR CONNECTOR

    Click here

  9. REMOVE RADIATOR RESERVOIR ASSEMBLY

    Click here

  10. REMOVE V-RIBBED BELT (w/ Viscous Heater)

    Click here

  11. REMOVE NO. 1 IDLER PULLEY (w/ Viscous Heater)

    Click here

  12. REMOVE NO. 3 IDLER PULLEY (w/ Viscous Heater)

    Click here

  13. REMOVE V-RIBBED BELT

    Click here

  14. DRAIN POWER STEERING FLUID

  15. DISCONNECT NO. 1 OIL RESERVOIR TO PUMP HOSE


    1. A01X16R

      Slide the clip and disconnect the No. 1 oil reservoir to pump hose from the vane pump.

  16. DISCONNECT POWER STEERING OIL PRESSURE SWITCH CONNECTOR


    1. A01X0J0

      Disconnect the 2 connectors.

  17. REMOVE PRESSURE FEED TUBE ASSEMBLY


    1. A01XAO3

      Remove the union bolt, union and disconnect the pressure feed tube.

    2. Remove the gasket.

  18. REMOVE VANE PUMP ASSEMBLY


    1. A01X1FY

      Remove the 2 nuts and vane pump.

    2. Remove the O-ring from the vane pump.