VANE PUMP(for 3UR-FE) REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE FRONT WHEEL RH

  4. REMOVE FRONT FENDER APRON TRIM PACKING A

    Click here

  5. REMOVE V-BANK COVER SUB-ASSEMBLY

    Click here

  6. REMOVE AIR CLEANER HOSE ASSEMBLY

    Click here

  7. REMOVE AIR CLEANER ASSEMBLY

    Click here

  8. REMOVE FAN AND GENERATOR V BELT

    Click here

  9. DRAIN POWER STEERING FLUID

  10. DISCONNECT POWER STEERING OIL PRESSURE SENSOR CONNECTOR (w/o Variable Flow Control Solenoid Valve)


    1. B001XSV

      Detach the wire harness clamp and disconnect the connector.

  11. DISCONNECT PRESSURE FEED TUBE (w/o Variable Flow Control Solenoid Valve)


    1. B001VZVE02
      Text in Illustration
      *1 Pressure feed tube

      Remove the union bolt and disconnect the pressure feed tube.

    2. Remove the gasket.

  12. DISCONNECT PRESSURE FEED TUBE ASSEMBLY (w/ Variable Flow Control Solenoid Valve)


    1. B001W2S

      Detach the 2 wire harness clamps and disconnect the 2 connectors.

    2. B001WIP

      Remove the union bolt and disconnect the pressure feed tube.

    3. Remove the gasket.

  13. DISCONNECT SUCTION HOSE (w/o Variable Flow Control Solenoid Valve)


    1. B001VVW

      Slide the clip and disconnect the suction hose from the vane pump.

  14. DISCONNECT NO. 1 OIL RESERVOIR TO PUMP HOSE (w/ Variable Flow Control Solenoid Valve)


    1. B001X7E

      Slide the clip and disconnect the No. 1 oil reservoir to pump hose from the oil reservoir.

    2. Remove the bolt and No. 1 oil reservoir to pump hose from the vane pump.

  15. REMOVE VANE PUMP ASSEMBLY


    1. B001WFQ

      Remove the 2 bolts and vane pump.