VANE PUMP(for 1GR-FE) REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE V-BANK COVER SUB-ASSEMBLY

    Click here

  4. REMOVE FAN AND GENERATOR V BELT

    Click here

  5. DRAIN POWER STEERING FLUID

  6. DISCONNECT POWER STEERING OIL PRESSURE SWITCH CONNECTOR

    B001WBB

    1. Disconnect the connector.

    2. Detach the wire harness clamp from the bracket.

  7. DISCONNECT NO. 1 OIL RESERVOIR TO PUMP HOSE

    B001XQT

    1. Slide the clip and disconnect the No.1 oil reservoir to pump hose from the vane pump.

  8. DISCONNECT PRESSURE FEED TUBE


    1. B001XEY

      Remove the union bolt and disconnect the pressure feed tube.

    2. Remove the gasket.

  9. REMOVE VANE PUMP ASSEMBLY

    B001Y0N

    1. Remove the 2 bolts and vane pump.