VANE PUMP(for 1UR-FE) REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE FRONT WHEEL RH

  4. REMOVE FRONT FENDER APRON TRIM PACKING A

    Click here

  5. REMOVE V-BANK COVER SUB-ASSEMBLY

    Click here

  6. REMOVE AIR CLEANER AND HOSE

    Click here

  7. REMOVE FAN AND GENERATOR V BELT

    Click here

  8. DRAIN POWER STEERING FLUID

  9. DISCONNECT POWER STEERING OIL PRESSURE SENSOR CONNECTOR


    1. A01X66R

      Detach the wire harness clamp and disconnect the connector.

  10. DISCONNECT PRESSURE FEED TUBE


    1. A01X0K3E02
      Text in Illustration
      *1 Pressure Feed Tube

      Remove the bolt and disconnect the pressure feed tube.

    2. Remove the gasket.

  11. DISCONNECT SUCTION HOSE


    1. A01X1XB

      Slide the clip and disconnect the suction hose from the vane pump.

  12. REMOVE VANE PUMP ASSEMBLY


    1. A01X8YE

      Remove the 2 bolts and vane pump.