PARKING BRAKE ASSEMBLY REASSEMBLY

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedures for the LH side and RH side.

  • The procedures listed below are for the LH side.

PROCEDURE


  1. INSTALL PARKING BRAKE ANCHOR BLOCK


    1. A01WZ4B

      Install the anchor block with the 2 nuts.

      Torque:
      86 N*m  { 877 kgf*cm, 63 ft.*lbf }

  2. CONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY


    1. A01X1CL

      Connect the No. 3 parking brake cable with the bolt.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

  3. INSTALL PARKING BRAKE SHOE LEVER LH


    1. A01X07IE01
      *1 High temperature grease
      *2 for LH:
      *3 for RH:

      Apply high temperature grease to the parking brake anchor block.

    2. Install the parking brake shoe lever to the No. 3 parking brake cable.

      Note

      Be carefully to distinguish between the parking brake shoe lever RH and LH.

  4. INSTALL NO. 2 PARKING BRAKE SHOE ASSEMBLY LH


    1. Apply high temperature grease to the areas of the backing plate that contact the shoe.

    2. A01X88HE03

      Using SST, install the No. 2 parking brake shoe with the shoe hold down spring pin, compression spring and shoe hold down spring cup.

      SST
      09718-00011

  5. INSTALL NO. 1 PARKING BRAKE SHOE ASSEMBLY LH


    1. Apply high temperature grease to the areas of the backing plate that contact the shoe.

    2. A01X0X7E01
      *1 High temperature grease

      Apply high temperature grease to the thread and all joining areas of the parking brake shoe adjuster screw set.

    3. A01X4ON

      Set the No. 1 parking brake shoe and shoe adjuster screw set in place.

    4. A01X32C

      Connect the tension spring.

    5. A01X9N5E02

      Using SST, install the shoe hold down spring pin, compression spring and shoe hold down spring cup.

      SST
      09718-00011

  6. INSTALL PARKING BRAKE SHOE RETURN SPRING


    1. A01XA0IE02

      Using SST, install the shoe return spring.

      SST
      09703-30011

  7. CHECK PARKING BRAKE INSTALLATION


    1. Check that each part is installed properly.

      A01X0JKE01
      *1 for LH:
      *2 for RH:
      *3 Front

  8. INSTALL REAR DISC


    1. A01X3Q7E09
      *1 Matchmark

      While aligning the matchmarks, install the rear disc.

  9. CONNECT REAR DISC BRAKE CYLINDER ASSEMBLY LH


    1. A01X644

      Connect the rear disc brake cylinder with 2 new bolts.

      Torque:
      95 N*m  { 969 kgf*cm, 70 ft.*lbf }

      Note


      • Do not twist the brake hose.

      • Make sure that the bolts are free from damage and foreign matter.

      • Do not overtighten the bolts.

  10. ADJUST PARKING BRAKE

    Click here

  11. INSTALL REAR WHEEL LH

    Torque:
    for Aluminum Wheel
    131 N*m  { 1336 kgf*cm, 97 ft.*lbf }
    for Steel Wheel
    209 N*m  { 2131 kgf*cm, 154 ft.*lbf }