PARKING BRAKE ASSEMBLY DISASSEMBLY

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedures for the LH side and RH side.

  • The procedures listed below are for the LH side.

PROCEDURE


  1. REMOVE REAR WHEEL LH

  2. DISCONNECT REAR DISC BRAKE CYLINDER ASSEMBLY LH


    1. A01X644

      Remove the 2 bolts and disconnect the rear disc brake cylinder.

      Note


      • Do not disconnect the flexible hose from the disc brake cylinder.

      • Do not twist or bend the flexible hose.

    2. Hang the disc brake cylinder with a piece of wire.

  3. REMOVE REAR DISC


    1. A01X3Q7E09
      *1 Matchmark

      Put matchmarks on the rear disc and axle hub if planning to reuse the disc.

    2. A01XBGS

      Turn the shoe adjuster until the disc turns freely, and then remove the disc.

  4. REMOVE PARKING BRAKE SHOE RETURN SPRING


    1. A01XA0IE02

      Using SST, remove the return spring.

      SST
      09703-30011

  5. REMOVE NO. 1 PARKING BRAKE SHOE ASSEMBLY LH


    1. A01X9N5E02

      Using SST, remove the shoe hold down spring cup, compression spring and shoe hold down spring pin.

      SST
      09718-00011
    2. A01X32C

      Disconnect the tension spring from the No. 1 parking brake shoe.

    3. A01X4ON

      Remove the No. 1 parking brake shoe and shoe adjuster screw set.

  6. REMOVE NO. 2 PARKING BRAKE SHOE ASSEMBLY LH


    1. A01X88HE03

      Using SST, remove the shoe hold down spring cup, compression spring and shoe hold down spring pin.

      SST
      09718-00011

    2. Remove the No. 2 parking brake shoe.

  7. REMOVE PARKING BRAKE SHOE LEVER LH


    1. Disconnect the No. 3 parking brake cable from the parking brake shoe lever.

    2. A01X4JQ

      Remove the parking brake shoe lever.

  8. REMOVE NO. 3 PARKING BRAKE CABLE ASSEMBLY


    1. A01X1CL

      Remove the bolt and No. 3 parking brake cable.

  9. REMOVE PARKING BRAKE ANCHOR BLOCK


    1. A01WZ4B

      Remove the 2 nuts and anchor block.