BRAKE PEDAL(for LHD) INSTALLATION

PROCEDURE

1. Click here

   INSTALL BRAKE PEDAL SUPPORT ASSEMBLY

   
   
   1. 

      Table 1.

      *1	for Automatic Transmission:
      *2	for Manual Transmission:

      Install the brake pedal support assembly with the 4 nuts.

      14 N*m

      145 kgf*cm

      10 ft.*lbf

   2. 

      Table 2.

      *1	for Automatic Transmission:
      *2	for Manual Transmission:

      Install the brake pedal support reinforcement set bolt.

      16 N*m

      163 kgf*cm

      12 ft.*lbf

   3. Tighten the hexagon bolt.

      23 N*m

      239 kgf*cm

      17 ft.*lbf

      Tip:

      Hold the bolt in place and tighten the nut.

2. Click here

   INSTALL PUSH ROD PIN

   
   

   1. Apply a light coat of lithium soap base glycol grease to the inner surface of the hole on the brake pedal lever.

   2. 

      Table 3.

      *1	for Automatic Transmission:
      *2	for Manual Transmission:

      Set the master cylinder push rod clevis in place, insert the push rod pin from the outside of the vehicle and then install a new clip.

3. Click here

   INSTALL STOP LIGHT SWITCH ASSEMBLY

   
   

   1. Install the stop light switch (Click here).

   2. Connect the stop light switch connector.

4. Click here

   INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY

   Click here

5. Click here

   INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

   Click here

6. Click here

   INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

   Click here

7. Click here

   INSTALL COWL SIDE TRIM BOARD LH

   Click here

8. Click here

   INSTALL FRONT DOOR SCUFF PLATE LH

   Click here

9. Click here

   CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

   Note:

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

10. Click here

    CHECK BRAKE PEDAL HEIGHT

    Click here

11. Click here

    CHECK PEDAL FREE PLAY

    Click here

12. Click here

    CHECK PEDAL RESERVE DISTANCE

    Click here