Click here

BRAKE PEDAL(for LHD) REMOVAL

Click here
Click here

PROCEDURE


  1. Click here

    PRECAUTION

    Note:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).

  2. Click here

    DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  3. Click here

    REMOVE FRONT DOOR SCUFF PLATE LH

    Click here

  4. Click here

    REMOVE COWL SIDE TRIM BOARD LH

    Click here

  5. Click here

    REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    Click here

  6. Click here

    REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

    Click here

  7. Click here

    REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY

    Click here

  8. Click here

    REMOVE NO. 2 CONNECTOR HOLDER


    1. B001Z3Z

      Loosen the bolt and disconnect the connector from the No. 2 connector holder.

      Table 1. Text in Illustration
      B001ZCQ Remove in this Direction
    2. B001WCRE01

      Disconnect the wire harness clamp from the brake pedal support assembly.

    3. Detach the two claws (A) of the No. 2 connector holder.

      Table 2. Text in Illustration
      B001ZCQ Pull Towards You

    4. Unlock the claw (B), and then pull the No. 2 connector holder towards you to remove it.

  9. Click here

    REMOVE PUSH ROD PIN


    1. B001XFME02

      Remove the clip and push rod pin from the brake pedal lever.

      Table 3. Text in Illustration
      *A for Automatic Transmission
      *B for Manual Transmission
  10. Click here

    REMOVE STOP LIGHT SWITCH ASSEMBLY


    1. Disconnect the stop light switch connector.

    2. Remove the stop light switch (Click here).

  11. Click here

    REMOVE BRAKE PEDAL SUPPORT ASSEMBLY


    1. B001XMBE01

      Loosen the hexagon bolt.

      Table 4. Text in Illustration
      *A for Automatic Transmission
      *B for Manual Transmission
      Tip:

      Hold the bolt in place and loosen the nut.

      Note:

      Only loosen the nut. Do not remove the bolt or nut.

    2. Remove the brake pedal support reinforcement set bolt.

    3. B001XWQE02

      Remove the 4 nuts and brake pedal support assembly.

      Table 5. Text in Illustration
      *A for Automatic Transmission
      *B for Manual Transmission