CRAWL SWITCH(w/ Entry and Start System) INSPECTION

PROCEDURE


  1. INSPECT INTEGRATION CONTROL AND PANEL ASSEMBLY (CRAWL SWITCH)

    A01XB7JE01
    Text in Illustration
    *1 CRAWL ON/OFF Switch
    *2 Turn Assist Function Switch
    *3 CRAWL Speed Selector Switch
    *a

    Component without harness connected:

    (Integration Control and Panel Assembly (CRAWL Switch))

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      15 (SW02) - 10 (E) Speed selector switch: Medium 10 kΩ or higher
      Speed selector switch: Medium-high
      Speed selector switch: High
      Speed selector switch: Low Below 1 Ω
      Speed selector switch: Medium-low
      14 (ECU2) - 10 (E) Speed selector switch: Medium-low 10 kΩ or higher
      Speed selector switch: Medium
      Speed selector switch: Medium-high
      Speed selector switch: Low Below 1 Ω
      Speed selector switch: High
      13 (SW04) - 10 (E) Speed selector switch: Low 10 kΩ or higher
      Speed selector switch: Medium-low
      Speed selector switch: Medium
      Speed selector switch: Medium-high Below 1 Ω
      Speed selector switch: High
      16 (HSW) - 10 (E) ON/OFF switch: Pressed Below 1 Ω
      ON/OFF switch: Not pressed 10 kΩ or higher
      12 (ECU) - 10 (E) Turn assist function switch: Pressed Below 1 Ω
      Turn assist function switch: Not pressed 10 kΩ or higher

      If the result is not as specified, replace the integration control and panel assembly (CRAWL switch).