STEERING ANGLE SENSOR REMOVAL

PROCEDURE


  1. PLACE FRONT WHEELS FACING STRAIGHT AHEAD

  2. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


    1. Disable the Autoaway/Return function by changing the customize parameter Click here.

      Note

      Record the current customize parameter setting (whether the Autoaway/Return function is enabled or disabled) in order to restore the current setting after finishing the operation.

      Tech Tips

      Performing the above operation causes the Autoaway/Return function to be disabled when the ignition switch is turned off.

    2. Turn the ignition switch on. Operate the tilt and telescopic switch to fully extend and lower the steering column.

    3. Turn the ignition switch off and disconnect the cable from the negative (-) battery terminal.

      Note

      When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE LOWER NO. 2 STEERING WHEEL COVER

    Click here

  5. REMOVE LOWER NO. 3 STEERING WHEEL COVER

    Click here

  6. REMOVE STEERING PAD

    Click here

  7. REMOVE STEERING WHEEL ASSEMBLY

    Click here

  8. REMOVE LOWER STEERING COLUMN COVER

    Click here

  9. REMOVE UPPER STEERING COLUMN COVER

    Click here

  10. REMOVE SPIRAL CABLE SUB-ASSEMBLY

    Click here

  11. REMOVE STEERING ANGLE SENSOR


    1. A01X3ET

      Detach the 6 claws and remove the steering angle sensor.