STEERING ANGLE SENSOR REMOVAL

PROCEDURE


  1. PLACE FRONT WHEELS FACING STRAIGHT AHEAD

  2. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


    1. Disable the Autoaway/Return function by changing the customize parameter Click here.

      Note

      Record the current customize parameter setting (whether the Autoaway/Return function is enabled or disabled) in order to restore the current setting after finishing the operation.

      Tech Tips

      Performing the above operation causes the Autoaway/Return function to be disabled when the ignition switch is turned off.

    2. Turn the ignition switch on. Operate the tilt and telescopic switch to fully extend and lower the steering column.

    3. Turn the ignition switch off and disconnect the cable from the negative (-) battery terminal.

      Note

      When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE STEERING WHEEL ASSEMBLY

    Click here

  5. REMOVE LOWER STEERING COLUMN COVER


    1. for Power Tilt and Power Telescopic Steering Column:

      Click here

    2. for Manual Tilt and Manual Telescopic Steering Column:

      Click here

  6. REMOVE UPPER STEERING COLUMN COVER


    1. for Power Tilt and Power Telescopic Steering Column:

      Click here

    2. for Manual Tilt and Manual Telescopic Steering Column:

      Click here

  7. REMOVE SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY

    Note


    • Do not replace the spiral with sensor cable sub-assembly with the battery connected and the ignition switch on (IG).

    • Do not rotate the spiral with sensor cable sub-assembly with the battery connected and the ignition switch on (IG).

    • When rotating the spiral with sensor cable sub-assembly to check the operation of the sub-assembly (checking for abnormal noise, checking the Data List, etc.), make sure to perform the inspection with the steering wheel assembly installed.


    1. Slide the airbag connector slider as shown in the illustration and disconnect the airbag connector from the spiral with cable sensor sub-assembly.

      B001XG5E01
      Text in Illustration
      *A w/ Steering Heater *B w/o Steering Heater

    2. Disconnect each connector from the spiral with sensor cable sub-assembly.

    3. B001W46

      Detach the 3 claws and remove the spiral with sensor cable sub-assembly.