REAR SPEED SENSOR INSTALLATION

PROCEDURE

1. INSTALL REAR SPEED SENSOR LH

   
   

   1. 

      Install the speed sensor with the nut.

      Torque:

      8.3 N*m  { 85 kgf*cm, 73 in.*lbf }

      Note

      
      

      • Make sure there are no pieces of iron or other foreign matter attached to the sensor tip.

      • While inserting the speed sensor into the knuckle hole, do not strike or damage the sensor tip.

      • After installing the speed sensor, make sure there is no clearance or foreign matter between the sensor stay part and the knuckle.

      • Make sure there is no foreign matter attached to the speed sensor rotor.

2. INSTALL REAR SPEED SENSOR RH

   
   

   1. 

      Install the speed sensor with the nut.

      Torque:

      8.3 N*m  { 85 kgf*cm, 73 in.*lbf }

      Note

      
      

      • Make sure there are no pieces of iron or other foreign matter attached to the sensor tip.

      • While inserting the speed sensor into the knuckle hole, do not strike or damage the sensor tip.

      • After installing the speed sensor, make sure there is no clearance or foreign matter between the sensor stay part and the knuckle.

      • Make sure there is no foreign matter attached to the speed sensor rotor.

3. INSTALL SKID CONTROL SENSOR WIRE

   
   

   1. 

      Install the sensor clamp with the bolt.

      Torque:

      13 N*m  { 127 kgf*cm, 9 ft.*lbf }

      Note

      Make sure the clamp rotation stopper touches the installation position.

   2. Connect the connector.

      Note

      
      

      • Securely insert the connector.

      • When connecting the connector, do not twist the wire harness.

   3. 

      Install the sensor clamp with the bolt.

      Torque:

      13 N*m  { 127 kgf*cm, 9 ft.*lbf }

      Note

      Make sure the clamp rotation stopper touches the installation position.

   4. 

      Connect the speed sensor RH connector.

      Note

      
      

      • Securely connect the connector.

      • When connecting the connector, do not twist the wire harness.

   5. Attach the 3 clamps.

      

      Note

      
      

      • When attaching the clamps, do not twist the wire harness.

      • When attaching the clamps, securely insert them as shown in the illustration.

   6. Attach the 5 clamps.

      

      Note

      
      

      • When attaching the clamps, do not twist the wire harness.

      • When attaching the clamps, securely insert them as shown in the illustration.

   7. Attach the 2 clamps, and install the sensor clamp with the bolt.

      Torque:

      13 N*m  { 127 kgf*cm, 9 ft.*lbf }

      
   8. 

      Connect the speed sensor LH connector.

      Note

      
      

      • Securely connect the connector.

      • When connecting the connector, do not twist the wire harness.

4. INSTALL REAR WHEEL

   Torque:

   for Aluminum Wheel

   131 N*m  { 1336 kgf*cm, 97 ft.*lbf }

   for Steel Wheel

   209 N*m  { 2131 kgf*cm, 154 ft.*lbf }

5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

6. CHECK SPEED SENSOR SIGNAL

   
   

   1. w/ ABS:

      Check the speed sensor signal Click here.

   2. w/ VSC:

      Check the speed sensor signal Click here.