REAR SPEED SENSOR REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE REAR WHEEL

  4. REMOVE SKID CONTROL SENSOR WIRE


    1. B001WB2

      Disconnect the speed sensor LH connector.

    2. Detach the 2 clamps and remove the bolt and sensor clamp.

      B001WO7

    3. Detach the 5 clamps.

      B002040

    4. Detach the 3 clamps.

      B001WWA
    5. B001ZH4

      Disconnect the speed sensor RH connector.

    6. B001YQ6

      Remove the bolt.

    7. B001WT5

      Disconnect the connector, and remove the bolt and skid control sensor wire.

  5. REMOVE REAR SPEED SENSOR LH


    1. B001W7T

      Remove the nut and speed sensor.

      Note

      Pull out the sensor while trying as much as possible not to rotate it.

  6. REMOVE REAR SPEED SENSOR RH


    1. B001XW3

      Remove the nut and speed sensor.

      Note

      Pull out the sensor while trying as much as possible not to rotate it.