FRONT SPEED SENSOR REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE FRONT WHEEL

  4. REMOVE FRONT SKID CONTROL SENSOR WIRE LH


    1. B001Y7Y

      Disconnect the connector from the front speed sensor.

    2. Remove the bolt and harness clamp.

    3. Remove the nut and harness clamp.

    4. B001Y7M

      Remove the 2 bolts and 2 harness clamps.

    5. B001X2C

      w/o AHC:

      Disconnect the connector and then remove the bolt, harness clamp and sensor wire.

    6. B001WRC

      w/ AHC:

      Disconnect the 2 connectors and then remove the bolt, harness clamp and sensor wire.

  5. REMOVE FRONT SPEED SENSOR LH


    1. B001Z4J

      Remove the bolt and speed sensor from the knuckle.

      Note

      Pull out the sensor while trying as much as possible not to rotate it.

  6. REMOVE FRONT SKID CONTROL SENSOR WIRE RH


    1. B001Z9R

      Disconnect the connector from the front speed sensor.

    2. Remove the bolt and harness clamp.

    3. Remove the nut and harness clamp.

    4. w/o AHC:


      1. B001WUE

        Disconnect the connector.

      2. Detach the connector from the skid control sensor clamp.

      3. Remove the bolt and skid control sensor clamp.

      4. Remove the 2 bolts, 2 harness clamps and sensor wire.

    5. w/ AHC:


      1. B00201Q

        Disconnect the connector.

      2. Detach the connector from the skid control sensor clamp.

      3. Remove the bolt and skid control sensor clamp.

      4. Remove the 2 bolts and 2 harness clamps.

      5. B001Z9F

        Disconnect the connector and then remove the bolt, harness clamp and sensor wire.

  7. REMOVE FRONT SPEED SENSOR RH


    1. B001Z2N

      Remove the bolt and speed sensor from the knuckle.

      Note

      Pull out the sensor while trying as much as possible not to rotate it.