SKID CONTROL BUZZER INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Other than areas where instructions are provided, use the same procedures for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL SKID CONTROL BUZZER ASSEMBLY (for LHD)


    1. B001VX3

      Connect the buzzer connector.

      Note

      Securely connect the connector.

    2. Attach the clamp to install the buzzer.

      Note


      • Securely insert the clamp into the bracket.

      • If the buzzer is dropped, replace it.

  2. INSTALL SKID CONTROL BUZZER ASSEMBLY (for RHD)


    1. B001ZTB

      Connect the buzzer connector.

      Note

      Securely connect the connector.

    2. Attach the clamp to install the buzzer.

      Note


      • Securely insert the clamp into the bracket.

      • If the buzzer is dropped, replace it.

  3. INSTALL NO. 1 SWITCH HOLE BASE

    Click here

  4. INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

    Click here

  5. INSTALL COWL SIDE TRIM BOARD

    Click here

  6. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    Click here

  7. INSTALL FRONT DOOR SCUFF PLATE

    Click here

  8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.