SKID CONTROL BUZZER REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Other than areas where instructions are provided, use the same procedures for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE FRONT DOOR SCUFF PLATE

    Click here

  4. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    Click here

  5. REMOVE COWL SIDE TRIM BOARD

    Click here

  6. REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

    Click here

  7. REMOVE NO. 1 SWITCH HOLE BASE

    Click here

  8. REMOVE SKID CONTROL BUZZER ASSEMBLY (for LHD)


    1. B001VX3

      Detach the clamp and remove the buzzer.

    2. Disconnect the buzzer connector.

  9. REMOVE SKID CONTROL BUZZER ASSEMBLY (for RHD)


    1. B001ZTB

      Detach the clamp and remove the buzzer.

    2. Disconnect the buzzer connector.