ANTI-LOCK BRAKE SYSTEM, Diagnostic DTC:C1417

DTC Code DTC Name
C1417 High Power Supply Voltage Malfunction

DESCRIPTION

If a malfunction is detected in the power supply circuit, the skid control ECU (master cylinder solenoid) stores this DTC and the fail-safe function prohibits ABS/VSC/TRC operation.

This DTC is stored when the IG1 terminal voltage deviates from the DTC detection condition due to a malfunction in the power supply or charging circuit such as the battery or generator circuit, etc.

This DTC is cleared when the IG1 terminal voltage returns to normal.

DTC Code DTC Detection Condition Trouble Area
C1417 The IG1 terminal voltage is 17.4 V or higher for 0.8 seconds or more.

  • Charging system

  • Power source circuit

  • Internal power supply circuit of the skid control ECU (master cylinder solenoid)

WIRING DIAGRAM

Refer to DTC C1241 Click here.

CAUTION / NOTICE / HINT

Note

After replacing the master cylinder solenoid, perform zero point calibration Click here.

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (IG1 TERMINAL)


    1. Disconnect the skid control ECU (master cylinder solenoid) connector.

    2. B001W8TE03
      Text in Illustration
      *a

      Front view of wire harness connector

      (to Skid Control ECU [Master Cylinder Solenoid])

      Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      A24-46 (IG1) - Body ground

      Ignition switch ON

      (Engine running)

      		 11 to 14 V
      Result
      Result Proceed to
      OK A
      NG (for 1VD-FTV) B
      NG (for 1UR-FE) C
      NG (for 1GR-FE) D

    B

    GO TO CHARGING SYSTEM (ON-VEHICLE INSPECTION) Click here

    C

    GO TO CHARGING SYSTEM (ON-VEHICLE INSPECTION) Click here

    D

    GO TO CHARGING SYSTEM (ON-VEHICLE INSPECTION) Click here

    A

  2. RECONFIRM DTC


    1. Clear the DTC Click here.

    2. Turn the ignition switch off.

    3. Check if the same DTC is output Click here.

      Result
      Result Proceed to
      DTC is not output A
      DTC is output (for LHD) B
      DTC is output (for RHD) C

    A

    CHECK FOR INTERMITTENT PROBLEMS Click here

    B

    REPLACE MASTER CYLINDER SOLENOID Click here

    C

    REPLACE MASTER CYLINDER SOLENOID Click here