NETWORK GATEWAY ECU(for LHD) REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE NO. 1 INSTRUMENT PANEL FINISH CUSHION

    Click here

  4. REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH

    Click here

  5. REMOVE INSTRUMENT SIDE PANEL RH

    Click here

  6. REMOVE FRONT DOOR SCUFF PLATE RH

    Click here

  7. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    Click here

  8. REMOVE COWL SIDE TRIM BOARD RH

    Click here

  9. REMOVE FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY

    Click here

  10. REMOVE NO. 3 INSTRUMENT CLUSTER FINISH PANEL GARNISH

    Click here

  11. REMOVE INSTRUMENT PANEL BOX DOOR KNOB

    Click here

  12. REMOVE LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL

    Click here

  13. REMOVE WINDSHIELD WIPER RELAY ASSEMBLY

    Click here

  14. REMOVE COWL SIDE JUNCTION BLOCK RH


    1. B00202G

      Disconnect the 5 connectors.

    2. B001VMA

      Remove the screw and 2 nuts and pull out the cowl side junction block RH.

    3. B002025

      Detach the back side of the wire harness clamp and disconnect the 2 connectors.

  15. REMOVE NETWORK GATEWAY ECU


    1. B001WJZ

      Remove the bolt and network gateway ECU.