NETWORK GATEWAY ECU(for RHD) INSTALLATION

PROCEDURE

1. INSTALL NETWORK GATEWAY ECU

   
   

   1. Install the network gateway ECU with the nut.

   2. Connect the connector.

2. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY

   Click here

3. INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

   Click here

4. INSTALL NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH

   Click here

5. INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH

   Click here

6. INSTALL COWL SIDE TRIM BOARD RH

   Click here

7. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

   Click here

8. INSTALL INSTRUMENT SIDE PANEL RH

   Click here

9. INSTALL FRONT DOOR SCUFF PLATE RH

   Click here

10. INSTALL LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH

    Click here

11. INSTALL NO. 1 INSTRUMENT PANEL FINISH PANEL CUSHION

    Click here

12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

13. CHECK SRS WARNING LIGHT

    
    

    1. Check the SRS warning light Click here.