NETWORK GATEWAY ECU(for RHD) REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE NO. 1 INSTRUMENT PANEL FINISH PANEL CUSHION

    Click here

  4. REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH

    Click here

  5. REMOVE FRONT DOOR SCUFF PLATE RH

    Click here

  6. REMOVE INSTRUMENT SIDE PANEL RH

    Click here

  7. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    Click here

  8. REMOVE COWL SIDE TRIM BOARD RH

    Click here

  9. REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH

    Click here

  10. REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH

    Click here

  11. REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

    Click here

  12. REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY

    Click here

  13. REMOVE NETWORK GATEWAY ECU


    1. B001ZFV

      Disconnect the connector.

    2. Remove the nut and network gateway ECU.