NETWORK GATEWAY ECU(for RHD) REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Driver Side Knee Airbag)

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE FRONT DOOR SCUFF PLATE RH


    1. w/ Sliding Roof:

      Remove the front door scuff plate Click here.

    2. w/o Sliding Roof:

      Remove the front door scuff plate Click here.

  4. REMOVE NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION


    1. w/o Console Box Lid:


      1. Remove the No. 2 instrument panel finish panel cushion Click here.

    2. w/ Cool Box:


      1. Remove the No. 2 instrument panel finish panel cushion Click here.

    3. w/o Cool Box:


      1. Remove the No. 2 instrument panel finish panel cushion Click here.

  5. REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH


    1. w/o Console Box Lid:


      1. Remove the lower instrument panel pad sub-assembly RH Click here.

    2. w/ Cool Box:


      1. Remove the lower instrument panel pad sub-assembly RH Click here.

    3. w/o Cool Box:


      1. Remove the lower instrument panel pad sub-assembly RH Click here.

  6. REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH

    Click here

  7. REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH

    Click here

  8. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Floor Under Cover)

    Click here

  9. REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

    Click here

  10. REMOVE NO. 1 SWITCH HOLE BASE

    Click here

  11. REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY (w/ Driver Side Knee Airbag)

    Click here

  12. REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY (w/o Driver Side Knee Airbag)

    Click here

  13. REMOVE NETWORK GATEWAY ECU

    A01X383

    1. Disconnect the connector.

    2. Remove the nut and ECU.