REAR LOWER ARM INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedures for the RH side and LH side.

  • The procedures listed below are for the LH side.

  • A bolt without a torque specification is shown in the standard bolt chart Click here.

PROCEDURE


  1. TEMPORARILY INSTALL LOWER CONTROL ARM ASSEMBLY LH


    1. A01X2DW

      Temporarily install the lower control arm and 2 washers with the 2 bolts and 2 nuts.

  2. STABILIZE SUSPENSION

    Click here

  3. TIGHTEN LOWER CONTROL ARM ASSEMBLY LH


    1. Tighten the 2 nuts.

      Torque:
      150 N*m  { 1530 kgf*cm, 111 ft.*lbf }

      Note

      Perform this procedure with all 4 wheels on the ground.

  4. MEASURE VEHICLE HEIGHT (w/ KDSS)

    Click here

  5. CLOSE STABILIZER CONTROL WITH ACCUMULATOR HOUSING SHUTTER VALVE (w/ KDSS)

    Click here

  6. INSTALL STABILIZER CONTROL VALVE PROTECTOR (w/ KDSS)

    Click here