FRONT STABILIZER BAR(w/ KDSS) INSPECTION

PROCEDURE


  1. INSPECT FRONT STABILIZER LINK ASSEMBLY RH

    A01WZ6H

    1. Temporarily install the nut, and flip the ball joint stud back and forth 5 times as shown in the illustration.

    2. Use a torque wrench to turn the nut continuously at a rate of 2 to 3 seconds per turn. Take the torque reading on the fifth turn.

      Standard turning torque
      0.5 to 3.4 N*m (5.1 to 36 kgf*cm, 4.4 to 30 in.*lbf)

      • If the value is not within the specified range, replace the front stabilizer link with a new one.

    3. Check the dust boot for cracks or grease leakage.