FRONT UPPER SUSPENSION ARM INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedures for the RH side and LH side.

  • The procedures listed below are for the LH side.

  • A bolt without a torque specification is shown in the standard bolt chart Click here.

PROCEDURE


  1. TEMPORARILY INSTALL FRONT SUSPENSION UPPER ARM ASSEMBLY LH

    B001YOZ

    1. Temporarily install the suspension upper arm with the 2 washers, bolt and nut.

      Tech Tips

      After stabilizing the suspension, tighten the nut.

  2. CONNECT STEERING KNUCKLE LH


    1. Connect the steering knuckle to the suspension upper arm.

    2. Install a new nut and a new cotter pin.

      Torque:
      110 N*m  { 1122 kgf*cm, 81 ft.*lbf }

      Note

      If the holes for the cotter pin are not aligned, tighten the nut further up to 60°.

  3. CONNECT SKID CONTROL SENSOR WIRE

    B001YBJE05
    *1 Upper Arm
    *2 Steering Knuckle

    1. Connect the sensor wire to the steering knuckle and upper arm with the bolt and nut.

      Torque:
      13 N*m  { 133 kgf*cm, 9.6 ft.*lbf }

  4. STABILIZE SUSPENSION

    Click here

  5. TIGHTEN FRONT SUSPENSION UPPER ARM ASSEMBLY LH


    1. Tighten the nut.

      Torque:
      185 N*m  { 1886 kgf*cm, 136 ft.*lbf }

      Note

      Perform this procedure with all 4 wheels on the ground.

  6. INSTALL FRONT HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH (w/ Active Height Control)

    Click here

  7. INSTALL FRONT FENDER APRON TRIM PACKING D


    1. B001W70

      Install the apron trim packing with the 4 clips.

  8. INSTALL FRONT FENDER APRON TRIM PACKING B (w/ KDSS)


    1. B001WAJ

      Install the apron trim packing with the 3 clips.

  9. INSTALL FRONT FENDER APRON TRIM PACKING B (w/o KDSS)


    1. B001Y6M

      Install the apron trim packing with the 4 clips.

  10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/ Active Height Control)

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  11. PERFORM VEHICLE HEIGHT OFFSET CALIBRATION (w/ Active Height Control)


    1. Perform the vehicle height offset calibration Click here.

  12. ADJUST FRONT HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH (w/ Active Height Control)

    Click here

  13. PERFORM ZERO POINT CALIBRATION OF G SENSOR (w/ Active Height Control)


    1. Perform the zero point calibration of G sensor Click here.

  14. MEASURE VEHICLE HEIGHT (w/ KDSS)

    Click here

  15. CLOSE STABILIZER CONTROL WITH ACCUMULATOR HOUSING SHUTTER VALVE (w/ KDSS)

    Click here

  16. INSTALL STABILIZER CONTROL VALVE PROTECTOR (w/ KDSS)

    Click here

  17. ADJUST HEADLIGHT ASSEMBLY


    1. for Standard:

      Adjust the headlight Click here.

    2. for HID Headlight:

      Adjust the headlight Click here.