REAR UPPER ARM INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedures for the RH side and LH side.

  • The procedures listed below are for the LH side.

  • A bolt without a torque specification is shown in the standard bolt chart Click here.

PROCEDURE


  1. TEMPORARILY INSTALL REAR UPPER CONTROL ARM ASSEMBLY LH (w/ Active Height Control)


    1. B001XYG

      Temporarily install the rear upper control arm and 2 washers with the 2 bolts and 2 nuts.

  2. TEMPORARILY INSTALL REAR UPPER CONTROL ARM ASSEMBLY LH (w/o Active Height Control)


    1. B001X4B

      Temporarily install the rear upper control arm and 2 washers with the 2 bolts and 2 nuts.

  3. STABILIZE SUSPENSION

    Click here

  4. TIGHTEN REAR UPPER CONTROL ARM ASSEMBLY LH


    1. Tighten the 2 nuts.

      Torque:
      150 N*m  { 1530 kgf*cm, 111 ft.*lbf }

      Note

      Perform this procedure with all 4 wheels on the ground.

  5. INSTALL REAR STABILIZER CONTROL TUBE INSULATOR (w/ KDSS)


    1. B001YOG

      Install the rear stabilizer control tube insulator with the 2 bolts.

      Torque:
      18 N*m  { 184 kgf*cm, 13 ft.*lbf }

  6. INSTALL UPPER ARM BUSH HEAT INSULATOR (w/o KDSS)


    1. B001XFS

      Install the upper arm bush heat insulator with the bolt.

      Torque:
      18 N*m  { 184 kgf*cm, 13 ft.*lbf }

  7. CONNECT SPEED SENSOR WIRE HARNESS


    1. B001YUC

      Connect the speed sensor wire harness with the bolt.

      Torque:
      13 N*m  { 127 kgf*cm, 9 ft.*lbf }

  8. INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH (w/ Active Height Control)

    Click here

  9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/ Active Height Control)

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  10. PERFORM VEHICLE OFF SET CALIBRATION (w/ Active Height Control)


    1. Perform the vehicle off set calibration Click here.

  11. ADJUST REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH (w/ Active Height Control)

    Click here

  12. MEASURE VEHICLE HEIGHT (w/ KDSS)

    Click here

  13. CLOSE STABILIZER CONTROL WITH ACCUMULATOR HOUSING SHUTTER VALVE (w/ KDSS)

    Click here

  14. INSTALL STABILIZER CONTROL VALVE PROTECTOR (w/ KDSS)

    Click here

  15. ADJUST HEADLIGHT ASSEMBLY (w/ Active Height Control)


    1. for Standard:

      Adjust the headlight Click here.

    2. for HID:

      Adjust the headlight Click here.