REAR COIL SPRING REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedures for the RH side and LH side.

  • The procedures listed below are for the LH side.

PROCEDURE


  1. REMOVE STABILIZER CONTROL VALVE PROTECTOR (w/ KDSS)

    Click here

  2. OPEN STABILIZER CONTROL WITH ACCUMULATOR HOUSING SHUTTER VALVE (w/ KDSS)

    Click here

  3. REMOVE REAR WHEEL

  4. DRAIN BRAKE FLUID

    Click here

  5. DISCONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY

    Click here

  6. DISCONNECT NO. 2 PARKING BRAKE CABLE ASSEMBLY

    Click here

  7. DISCONNECT REAR AXLE BREATHER HOSE SUB-ASSEMBLY

    Click here

  8. SUPPORT REAR AXLE HOUSING ASSEMBLY

    Click here

  9. DISCONNECT REAR STABILIZER END BRACKET (w/ KDSS)


    1. A01X2SO

      Remove the 2 bolts and disconnect the stabilizer end bracket.

  10. DISCONNECT REAR STABILIZER LINK ASSEMBLY (w/ KDSS)


    1. A01X6EI

      Remove the nut and disconnect the stabilizer link from the stabilizer bar.

      Note

      Do not lose the ball Joint dust cover protector.

      Tech Tips

      If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud.

  11. DISCONNECT REAR STABILIZER END BRACKET LH (w/o KDSS)


    1. A01X67Q

      Remove the 2 bolts and disconnect the stabilizer end bracket.

  12. DISCONNECT REAR STABILIZER END BRACKET RH (w/o KDSS)


    1. Remove the 2 bolts and disconnect the stabilizer end bracket.

  13. DISCONNECT REAR LATERAL CONTROL ROD ASSEMBLY

    Click here

  14. DISCONNECT REAR FLEXIBLE HOSE

    Click here

  15. DISCONNECT REAR SHOCK ABSORBER ASSEMBLY LH


    1. A01X6MI

      Remove the bolt on the lower side of the shock absorber.

    2. Disconnect the shock absorber from the axle housing.

  16. DISCONNECT REAR SHOCK ABSORBER ASSEMBLY RH


    1. A01XA9H

      Remove the bolt on the lower side of the shock absorber.

    2. Disconnect the shock absorber from the axle housing.

  17. REMOVE REAR COIL SPRING LH


    1. While lowering the axle housing, remove the coil spring.

      Note

      Be careful not to snap the brake line.

  18. REMOVE HOLLOW SPRING SUB-ASSEMBLY


    1. Remove the hollow spring from the frame.