SUSPENSION CONTROL ECU INSTALLATION

PROCEDURE


  1. INSTALL SUSPENSION CONTROL ECU


    1. B001Y4X

      Attach the wire harness clamp and connect the connector.

    2. Install the ECU with the 2 bolts.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

  2. INSTALL REAR SIDE NO. 2 AIR DUCT (w/ Heater)

    Click here

  3. INSTALL FRONT QUARTER TRIM PANEL ASSEMBLY LH


    1. w/ Sliding Roof:

      Click here

    2. w/o Sliding Roof:

      Click here

  4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  5. PERFORM VEHICLE HEIGHT OFFSET CALIBRATION


    1. Perform the vehicle height offset calibration Click here.

  6. PERFORM ZERO POINT CALIBRATION OF G SENSOR


    1. Perform the zero point calibration of G sensor Click here.

  7. ADJUST HEADLIGHT ASSEMBLY


    1. for Halogen Headlight and LED Headlight:

      Click here