SUSPENSION CONTROL ECU REMOVAL

PROCEDURE


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  2. REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)

    Click here

  3. REMOVE REAR NO. 2 SEAT ASSEMBLY LH (except Face to Face Seat Type)


    1. Remove the rear No. 2 seat assembly LH Click here.

  4. REMOVE REAR NO. 2 SEAT ASSEMBLY RH (except Face to Face Seat Type)

    Tech Tips

    Use the same procedures described for the LH side.

  5. REMOVE REAR NO. 2 SEAT ASSEMBLY LH (for Face to Face Seat Type)


    1. Remove the rear No. 2 seat assembly LH Click here.

  6. REMOVE REAR NO. 2 SEAT ASSEMBLY RH (for Face to Face Seat Type)

    Tech Tips

    Use the same procedures described for the LH side.

  7. REMOVE REAR STEP COVER

    Click here

  8. REMOVE REAR DOOR SCUFF PLATE LH

    Click here

  9. REMOVE REAR FLOOR MAT REAR SUPPORT PLATE

    Click here

  10. REMOVE NO. 1 TONNEAU COVER HOLDER CAP (w/ Tonneau Cover)

    Click here

  11. REMOVE REAR SEAT COVER CAP (w/ Rear No. 2 Seat, except Face to Face Seat Type)

    Click here

  12. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY LH

    Click here

  13. REMOVE REAR SIDE NO. 2 AIR DUCT (w/ Heater)

    Click here

  14. REMOVE SUSPENSION CONTROL ECU


    1. B001Y4X

      Detach the wire harness clamp and disconnect the connector.

    2. Remove the 2 bolts and ECU.