HEIGHT CONTROL SENSOR(for Front Side) INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedures for the RH side and LH side.

  • The procedures listed below are for the LH side.

  • A bolt without a torque specification is shown in the standard bolt chart Click here.

PROCEDURE


  1. INSTALL FRONT HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH


    1. B001VY0

      Install the sensor with the bolt and nut.

      Torque:
      for bolt
      13 N*m  { 127 kgf*cm, 9 ft.*lbf }
      for nut
      5.6 N*m  { 57 kgf*cm, 50 in.*lbf }

    2. Connect the connector.

  2. INSTALL FRONT WHEEL

    Torque:
    for Aluminum Wheel
    131 N*m  { 1336 kgf*cm, 97 ft.*lbf }
    for Steel Wheel
    209 N*m  { 2131 kgf*cm, 154 ft.*lbf }

  3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. PERFORM VEHICLE HEIGHT OFFSET CALIBRATION


    1. Perform the vehicle height offset calibration Click here.

  5. ADJUST FRONT HEIGHT CONTROL SENSOR LINK SUB-ASSEMBLY

    Click here

  6. INSTALL FRONT FENDER APRON TRIM PACKING B

    Click here

  7. PERFORM ZERO POINT CALIBRATION OF G SENSOR


    1. Perform the zero point calibration of G sensor Click here.

  8. ADJUST HEADLIGHT ASSEMBLY


    1. for Halogen Headlight and LED Headlight:

      Click here