HEIGHT CONTROL SENSOR(for Front Side) ADJUSTMENT

PROCEDURE


  1. ADJUST FRONT HEIGHT CONTROL SENSOR LINK SUB-ASSEMBLY

    Note


    • Make adjustments from the link that deviates the most from the specified vehicle height value.

    • When the front and rear are at the same level, make adjustments from the front first.

    • If adjustment cannot be completed through the vehicle height offset calibration, adjust the sensor link using the following procedure.


    1. B001ZVQ

      Loosen the nut and adjust the link installation position by moving the height control sensor link up or down in the long hole of the bracket.

      Tech Tips

      When the link is moved 1 mm (0.0394 in.), the vehicle height changes by approximately 2 mm (0.0787 in.).

    2. Tighten the nut of the height control sensor link.

      Torque:
      5.6 N*m  { 57 kgf*cm, 50 in.*lbf }

  2. PERFORM VEHICLE HEIGHT OFFSET CALIBRATION


    1. Perform the vehicle height offset calibration Click here.

  3. PERFORM ZERO POINT CALIBRATION OF G SENSOR


    1. Perform the zero point calibration of G sensor Click here.

  4. ADJUST FRONT WHEEL ALIGNMENT


    1. Adjust the front wheel alignment Click here.

  5. ADJUST HEADLIGHT ASSEMBLY


    1. for Standard:

      Adjust the headlight Click here.

    2. for HID Headlight:

      Adjust the headlight (See page LIGHTING (EXT) > HEADLIGHT ASSEMBLY (for HID Headlight) > ADJUSTMENT).