ABSORBER CONTROL SWITCH INSPECTION

PROCEDURE


  1. INSPECT INTEGRATION CONTROL AND PANEL ASSEMBLY (SUSPENSION CONTROL SWITCH)


    1. A01XB7JE03
      Text in Illustration
      *1 Height Control Switch
      *2 Height Control OFF Switch
      *a

      Component without harness connected:

      (Integration Control and Panel Assembly (Suspension Control Switch))

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Height Control Switch
      Tester Connection Switch Condition Specified Condition
      4 (LO) - 10 (E) Down button of height control switch is pushed. Below 1 Ω
      Height control switch is not pushed or up button is pushed. 10 kΩ or higher
      8 (HI) - 10 (E) Up button of height control switch is pushed. Below 1 Ω
      Height control switch is not pushed or down button is pushed. 10 kΩ or higher
      Height Control OFF Switch
      Tester Connection Switch Condition Specified Condition
      7 (N) - 10 (E) Height control OFF switch is pushed. Below 1 Ω
      Height control OFF switch is not pushed. 10 kΩ or higher

      If the result is not as specified, replace the integration control and panel assembly (suspension control switch).