ABSORBER CONTROL SWITCH INSPECTION

PROCEDURE


  1. INSPECT SUSPENSION CONTROL SWITCH


    1. A01X6PRE08
      *1 Component without harness connected: (Suspension Control Switch)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Damping Force Control Switch
      Tester Connection Switch Condition Specified Condition
      5 (ECU2) - 16 (E) COMF Below 1 Ω
      Except COMF 10 kΩ or higher
      6 (ECU1) - 16 (E) SPORT Below 1 Ω
      Except SPORT 10 kΩ or higher
      Height Control Switch
      Tester Connection Switch Condition Specified Condition
      8 (LO) - 16 (E) Down button of height control switch is pushed. Below 1 Ω
      Height control switch is not pushed or up button is pushed. 10 kΩ or higher
      7 (HI) - 16 (E) Up button of height control switch is pushed. Below 1 Ω
      Height control switch is not pushed or down button is pushed. 10 kΩ or higher
      Height Control OFF Switch
      Tester Connection Switch Condition Specified Condition
      9 (N) - 16 (E) Height control OFF switch is pushed. Below 1 Ω
      Height control OFF switch is not pushed. 10 kΩ or higher

      If the result is not as specified, replace the suspension control switch.