ACTIVE HEIGHT CONTROL PUMP AND MOTOR DISASSEMBLY

PROCEDURE


  1. REMOVE HEIGHT CONTROL HOSE ASSEMBLY


    1. A01X6UUE03
      *1 Clamp
      *2 Clip
      *3 Height Control Hose

      Disconnect the clamp from the reservoir, then remove the 2 clips and hose.

  2. REMOVE HEIGHT CONTROL CAP TO RESERVOIR HOSE


    1. A01WZC1E01
      *1 Breather Plug

      Remove the 3 clips, 2 breather plugs and hose from the reservoir hose.

    2. A01X31M

      Pull the connector down to detach it and remove the hose from the reservoir tank.

  3. DISCONNECT NO. 4 FRAME WIRE


    1. A01X4X7E01
      *1 No. 4 Frame Wire

      Disconnect the 2 connectors, clamp and frame wire.

  4. REMOVE HEIGHT CONTROL COMPRESSOR BRACKET ASSEMBLY


    1. A01X9LY

      Remove the 3 nuts and bracket from the pump and motor.

  5. REMOVE HEIGHT CONTROL RESERVOIR ASSEMBLY


    1. A01XA1M

      Using a 5 mm hexagon wrench, remove the 5 bolts and reservoir from the pump and motor.

  6. REMOVE NO. 1 HEIGHT CONTROL BOLT CUSHION


    1. Remove the 3 bolt holders and 3 bolt cushions from the pump and motor.