ACTIVE HEIGHT CONTROL PUMP AND MOTOR INSTALLATION

PROCEDURE


  1. INSTALL HEIGHT CONTROL PUMP AND MOTOR ASSEMBLY


    1. A01X58Q

      Install the pump and motor with the 3 bolts.

      Torque:
      31 N*m  { 316 kgf*cm, 23 ft.*lbf }
    2. A01XAD5

      Connect the 2 connectors and 3 clamps.

  2. INSTALL HEIGHT CONTROL TUBE CLAMP


    1. A01X1YTE01
      *1 Height Control Tube Clamp

      Install the tube clamp with the 2 bolts.

      Torque:
      20 N*m  { 204 kgf*cm, 15 ft.*lbf }

    2. Connect the reservoir hose to the tube clamp.

  3. CONNECT REAR NO. 6 HEIGHT CONTROL TUBE


    1. A01X6IKE01
      *1 Union Nut Wrench
      *2 Fulcrum Length

      Using a union nut wrench, connect the control tube to the pump and motor.

      Torque:
      without union nut wrench
      15 N*m  { 155 kgf*cm, 11 ft.*lbf }
      with union nut wrench
      14 N*m  { 143 kgf*cm, 10 ft.*lbf }

      Tech Tips


      • Use a torque wrench with a fulcrum length of 300 mm (11.8 in.).

      • The torque value for use with a union nut wrench is effective when the union nut wrench is parallel to the torque wrench.

  4. BLEED AIR FROM SUSPENSION FLUID

    Click here

  5. CHECK FLUID LEVEL IN RESERVOIR

    Click here

  6. INSPECT FOR SUSPENSION FLUID LEAK

    Click here

  7. INSTALL FUEL TANK FILLER PIPE PROTECTOR


    1. A01X1OG

      Using a T30 "TORX" socket wrench, install the pipe protector with the 3 screws and grommet.

    2. Install the new grommet.

  8. INSTALL NO. 1 LUGGAGE COMPARTMENT SIDE COVER PROTECTOR

    A01X84A

    1. Install the protector with 2 new grommets.

    2. Install the 2 screws.

  9. INSTALL REAR BUMPER COVER


    1. for Standard:

      Install the bumper cover Click here.

    2. w/ Towing Hitch:

      Install the bumper cover Click here.

    3. w/ Pintle Hook:

      Install the bumper cover Click here.

    4. for Double Swing Out Type:

      Install the bumper cover Click here.

  10. INSTALL REAR QUARTER PANEL MUDGUARD RH

    Click here