FRONT DRIVE SHAFT ASSEMBLY INSTALLATION

PROCEDURE


  1. INSTALL FRONT DRIVE SHAFT ASSEMBLY LH


    1. Coat the lip of the differential oil seal with MP grease.

      Tech Tips

      Inspect the oil seal for wear or damage.

    2. Coat the spline of the inboard joint shaft assembly with hypoid gear oil.

    3. A01X3PL

      Align the shaft splines and install the drive shaft with a brass bar and hammer.

      Note


      • Set the snap ring with the opening side facing downward.

      • Be careful not to damage the oil seal.

      • If the outboard joint shaft is new, remove the anti-rust oil on the screw end with non-residue solvent.

      Tech Tips

      Whether the inboard joint shaft is in contact with the pinion shaft or not can be confirmed from the sound or feeling when tapping in the shaft.

  2. INSTALL FRONT AXLE ASSEMBLY LH

    Click here

  3. ADD DIFFERENTIAL OIL

    Click here

  4. INSTALL NO. 2 ENGINE UNDER COVER

    Click here

  5. INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

    Click here

  6. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH

    Click here

  7. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

    Click here