4WD CONTROL ECU(for RHD) INSTALLATION

PROCEDURE

1. INSTALL 4 WHEEL DRIVE CONTROL ECU

   
   

   1. Connect the 2 connectors to the 4 wheel drive control ECU.

   2. Attach the 2 guides.

   3. Install the 4 wheel drive control ECU with the bolt.

      Torque:

      13 N*m  { 127 kgf*cm, 9 ft.*lbf }

2. INSTALL STEERING CONTROL WITH JUNCTION BLOCK

   Click here

3. REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY (w/o Driver Side Knee Airbag)

   Click here

4. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY (w/ Driver Side Knee Airbag)

   Click here

5. INSTALL NO. 1 SWITCH HOLE BASE

   Click here

6. INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

   Click here

7. INSTALL COWL SIDE TRIM BOARD RH

   Click here

8. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Floor Under Cover)

   Click here

9. INSTALL FRONT DOOR SCUFF PLATE RH

   Click here

10. INSTALL NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH

    Click here

11. INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH

    Click here

12. INSTALL LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH

    Click here

13. INSTALL NO. 1 INSTRUMENT PANEL FINISH PANEL CUSHION

    Click here

14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

15. CHECK SRS WARNING LIGHT

    Click here