TRANSMISSION CASE OIL SEAL REPLACEMENT

PROCEDURE

1. Click here

   REMOVE MANUAL TRANSMISSION ASSEMBLY

   
   

   1. Remove the manual transmission (Click here).

2. Click here

   REMOVE FRONT BEARING RETAINER (MTM)

   
   

   1. Remove the 8 bolts and front bearing retainer.

3. Click here

   REMOVE TRANSMISSION FRONT BEARING RETAINER OIL SEAL

   
   

   1. Using a screwdriver, pry out the oil seal.

      Note:

      Be careful not to damage the oil seal and front bearing retainer contact surfaces.

      Tip:

      Tape the screwdriver tip before use.

4. Click here

   INSTALL TRANSMISSION FRONT BEARING RETAINER OIL SEAL

   
   

   1. Using SST and a press, drive in a new oil seal.

      09950-60010	09951-00460
      09950-70010	09951-07150

      Standard Drive in Depth
      15.4 to 16.2 mm (0.607 to 0.637 in.)

   2. Apply gear oil to the lip of the oil seal.

5. Table 1. *1 Seal Packing
   Click here

   INSTALL FRONT BEARING RETAINER (MTM)

   
   

   1. Apply seal packing to the front bearing retainer, as shown in the illustration.

      Seal Packing
      Toyota Genuine Seal Packing 1281, Three Bond 1281 or equivalent

      Note:

      Parts must be assembled within 10 minutes of application. Otherwise, the packing (FIPG) material must be removed and reapplied.

   2. Apply adhesive to 2 or 3 threads of the bolts.

      Adhesive
      Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent

   3. 

      Install the front bearing retainer with the 8 bolts.

      17 N*m

      170 kgf*cm

      12 ft.*lbf

6. Click here

   INSTALL MANUAL TRANSMISSION ASSEMBLY

   
   

   1. Install the manual transmission (Click here).