SPEED SENSOR(for Input Revolution Sensor) INSTALLATION

PROCEDURE


  1. INSTALL TRANSMISSION REVOLUTION SENSOR (NT)


    1. Apply a light coat of ATF to the O-ring of the transmission revolution sensor (NT).

    2. A01X721

      Attach the clamp to install the transmission revolution sensor (NT) to the clamp.

    3. Using a T30 ''TORX'' socket wrench, install the transmission revolution sensor (NT) and clamp with the bolt.

      Torque:
      6.8 N*m  { 69 kgf*cm, 60 in.*lbf }

      Note


      • When reusing the transmission revolution sensor (NT), inspect the O-ring.

      • Make sure that the O-ring is not cracked or jammed when installing the transmission revolution sensor (NT).

  2. INSTALL OIL PUMP ASSEMBLY


    1. A01X64U

      Coat 3 new oil seal rings with ATF, and install them to the input shaft.

      Note

      Do not expand the oil seal ring ends excessively.

    2. A01XC0O

      Coat 4 new clutch drum oil seal rings with ATF, and install them to the stator shaft groove.

      Note

      Do not expand the ring ends excessively.

      Tech Tips

      After installing the clutch drum oil seal rings, check that they rotate smoothly.

    3. B001Z8P

      Coat a new oil pump O-ring with ATF, and install it to the oil pump assembly.

    4. Clean and degrease the threads of the 11 bolts and the contact surfaces of the automatic transmission case sub-assembly and oil pump assembly with non-residue solvent.

      Note

      During installation, do not allow oil to contact the bolts or the surface of the oil pump body.

    5. Place the oil pump assembly through the input shaft, and align the bolt holes of the oil pump assembly with the automatic transmission case sub-assembly.

    6. Hold the input shaft, and lightly press the oil pump assembly to slide the oil seal rings into the front planetary gear assembly.

      Note

      Be careful not to damage the O-ring and oil seal rings.

    7. B001XUN

      Install the 11 bolts.

      Torque:
      25 N*m  { 250 kgf*cm, 18 ft.*lbf }
    8. A01X6IP

      Connect the connector to the transmission revolution sensor (NT).

  3. INSTALL AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY

    Click here

  4. INSTALL AUTOMATIC TRANSMISSION HOUSING

    Click here

  5. INSTALL AUTOMATIC TRANSMISSION ASSEMBLY

    Click here