COMBINATION SWITCH INSPECTION

PROCEDURE

1. INSPECT INTEGRATION CONTROL AND PANEL ASSEMBLY (w/o Active Height Control)

   
   
   1. 

      Text in Illustration

      *a	Component without harness connected (Integration Control and Panel Assembly)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection	Switch Condition	Specified Condition
      5 (E) - 6 (P)	Mode switch (ECT PWR) on	Below 1 Ω
      	Release mode switch (ECT PWR) off	10 kΩ or higher
      5 (E) - 8 (2nd)	Mode switch being pushed and held (ECT 2nd)	Below 1 Ω
      	Mode switch not pushed (ECT 2nd)	10 kΩ or higher

      If the result is not as specified, replace the integration control and panel assembly.

2. INSPECT INTEGRATION CONTROL AND PANEL ASSEMBLY (w/ Active Height Control)

   
   
   1. 

      Text in Illustration

      *a	Component without harness connected (Integration Control and Panel Assembly)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection	Switch Condition	Specified Condition
      5 (E) - 6 (P)	Mode switch being pushed and held (SPORTS S/S+)	Below 1 Ω
      	Mode switch not pushed (SPORTS S/S+)	10 kΩ or higher
      5 (E) - 2 (B)	Mode switch being pushed and held (NORMAL)	Below 1 Ω
      	Mode switch not pushed (NORMAL)	10 kΩ or higher
      5 (E) - 3 (ECU)	Mode switch being pushed and held (COMF/ECO)	Below 1 Ω
      	Mode switch not pushed (COMF/ECO)	10 kΩ or higher

      If the result is not as specified, replace the integration control and panel assembly.