TORQUE CONVERTER AND DRIVE PLATE INSPECTION

PROCEDURE


  1. INSPECT TORQUE CONVERTER ASSEMBLY


    1. Inspect the one-way clutch.


      1. B001Y13

        Press on the spline of the stator with a finger and rotate the spline. Check that the spline rotates smoothly when turned clockwise and rotates with difficulty when turned counterclockwise.

        Text in Illustration
        B001XPG Difficult
        B001WGT Smooth

        If necessary, clean the torque converter assembly and recheck the one-way clutch. Replace the torque converter assembly if the one-way clutch still fails the inspection.

    2. B001ZB6E08
      Text in Illustration
      *a Sample showing maximum allowable amount of powder in ATF
      *b Full Scale

      Inspect the torque converter assembly.

      If any of the following problems are present, replace the torque converter assembly.


      • A metallic sound is emitted from the torque converter assembly during the stall test or when the shift lever is moved to N.

      • The one-way clutch turns smoothly or locks in both directions.

      • The amount of powder in the ATF is more than the sample shown in the illustration (refer to the sample).

      Tech Tips

      The sample shows approximately 0.025 liters (0.026 US qts, 0.022 Imp. qts) of ATF in petri dish, which has been taken from a torque converter assembly.

    3. Replace the ATF in the torque converter assembly.


      1. If the ATF is discolored or has a foul odor, stir the ATF in the torque converter assembly and drain it before replacing the ATF.

    4. B001Y9PE78
      Text in Illustration
      *a CORRECT
      *b INCORRECT
      *c Bottom is damaged

      Prevent deformation of the torque converter and damage to the oil pump gear.

      Note

      Make sure that all of the bolts are the same length and that the specified bolts are used.

      Tech Tips

      If there is any damage to the tip of a bolt for the torque converter assembly or to the bottom of a bolt hole, replace the bolt and torque converter assembly.

  2. INSPECT DRIVE PLATE


    1. B001ZWLE01

      Check the drive plate for damage.

      Text in Illustration
      B001YD9 Measurement Point

    2. Set up a dial indicator and measure the runout at the 6 areas on the drive plate surface that contact the torque converter assembly.

      Maximum Runout
      0.30 mm (0.0118 in.)

      If the runout is more than the maximum or the drive plate is damaged, replace the drive plate.

      Click here