PARK / NEUTRAL POSITION SWITCH REMOVAL

PROCEDURE


  1. DISCONNECT FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY


    1. Move the shift lever to N.

    2. B001XHB

      Remove the clip and pin, and disconnect the floor shift gear shifting rod sub-assembly from the transmission control shaft lever RH.

  2. REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY


    1. Disconnect the park/neutral position switch assembly connector.

    2. B001Y46

      Remove the nut, spring washer and transmission control shaft lever RH.

    3. Remove the collar and transmission control rod bush from the transmission control shaft lever RH.

    4. B001YO0

      Using a screwdriver, bend the tabs of the lock washer.

    5. B001Z05

      Remove the lock nut and lock washer.

    6. B00201E

      Remove the bolt and park/neutral position switch assembly.

      Tech Tips

      Make sure that the manual valve lever shaft has not been rotated prior to installing the park/neutral position switch assembly as the detent spring may become detached from the manual valve lever shaft.