TRANSMISSION WIRE REMOVAL

PROCEDURE

1. DRAIN AUTOMATIC TRANSMISSION FLUID

   
   

   1. 

      Remove the drain plug and gasket from the automatic transmission assembly and drain the ATF.

   2. Install a new gasket and the drain plug to the automatic transmission assembly.

      Torque:

      20 N*m  { 204 kgf*cm, 15 ft.*lbf }

2. REMOVE AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY

   
   

   1. 

      Remove the 10 bolts, automatic transmission oil pan sub-assembly and automatic transmission oil pan gasket from the automatic transmission case sub-assembly.

      Note

      Some fluid will remain in the automatic transmission oil pan sub-assembly. Remove all of the bolts, and carefully remove the automatic transmission oil pan sub-assembly.

   2. Remove the 4 transmission oil cleaner magnets from the automatic transmission oil pan sub-assembly.

   3. Examine the particles in the automatic transmission oil pan sub-assembly.

      
      

      1. Collect any steel chips with the removed transmission oil cleaner magnets. Carefully inspect the foreign matter and particles in the automatic transmission oil pan sub-assembly and on the transmission oil cleaner magnets to anticipate the type of wear you will find in the automatic transmission assembly.

         Steel (magnetic): bearing, gear and clutch plate wear

         Brass (non-magnetic): bush wear

3. DISCONNECT TRANSMISSION WIRE

   
   
   1. 

      Text in Illustration

      *1	Temperature Sensor Clamp
      *2	Temperature Sensor

      Remove the 2 bolts and the 2 temperature sensor clamps, and disconnect the 2 temperature sensors.

   2. Disconnect the 7 solenoid valve connectors and transmission wire from the transmission valve body assembly.

4. REMOVE TRANSMISSION WIRE

   
   

   1. 

      Disconnect the transmission wire connector.

      Tech Tips

      Detach the claw, press down the lever, and disconnect the transmission wire connector.

   2. Remove the bolt and pull out the transmission wire from the automatic transmission case sub-assembly.

   3. 

      Remove the O-ring from the connector of transmission wire.

   4. 

      Remove the 2 O-rings from the 2 temperature sensors.