COMBINATION SWITCH(w/o Entry and Start System) INSPECTION

PROCEDURE


  1. INSPECT SUSPENSION CONTROL SWITCH (COMBINATION SWITCH)


    1. A01X6PRE05
      Text in Illustration
      *a

      Component without harness connected

      (Suspension Control Switch (Combination Switch))

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      3 (P) - 16 (E) Mode switch being pushed and held (PWR) Below 1 Ω
      Mode switch not pushed (PWR) 10 kΩ or higher
      4 (2ND) - 16 (E) Mode switch being pushed and held (2ND) Below 1 Ω
      Mode switch not pushed (2ND) 10 kΩ or higher

      If the result is not as specified, replace the suspension control switch (combination switch).