PARK / NEUTRAL POSITION SWITCH INSTALLATION

PROCEDURE


  1. INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY

    Tech Tips

    Make sure that the manual valve lever shaft has not been rotated prior to installing the park/neutral position switch as the detent spring may become detached from the manual valve lever shaft.


    1. Clean the bolt and the bolt hole.

    2. Apply adhesive to 2 or 3 threads on the end of the bolt.

      Adhesive
      Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent
    3. A01X4I8

      Temporarily install the park/neutral position switch assembly with the bolt.

      Tech Tips

      Tighten the bolt to the specified torque when adjusting the park/neutral position switch assembly.

    4. A01WZZO

      Install the lock washer and the lock nut to the park/ neutral position switch assembly.

      Torque:
      6.9 N*m  { 70 kgf*cm, 61 in.*lbf }
    5. B001XBW

      Temporarily install the transmission control shaft lever RH to the manual valve lever shaft with the spring washer and nut.

      Tech Tips

      Tighten the nut to the specified torque when adjusting the park/neutral position switch assembly.

    6. A01X7EHE04
      Text in Illustration
      *1 Transmission Control Shaft Lever RH

      Turn the control shaft lever RH counterclockwise until it stops, and then turn it clockwise 2 notches to set it to the N position.

    7. Remove the nut, spring washer and transmission control shaft lever RH from the manual valve lever shaft.

    8. A01X9ALE02
      Text in Illustration
      *a Neutral Basic Line
      *b Groove

      Align the groove with the neutral basic line.

    9. Hold the switch in the position described above and tighten the bolt.

      Torque:
      13 N*m  { 133 kgf*cm, 10 ft.*lbf }
    10. A01X7HS

      Using a screwdriver, bend the tabs of the lock washer.

      Bend at least 2 of the lock washer tabs.

    11. Install the transmission control rod bush and collar to the transmission control shaft lever RH.

    12. B001XBW

      Install the transmission control shaft lever RH with the spring washer and nut.

      Torque:
      16 N*m  { 163 kgf*cm, 12 ft.*lbf }

    13. Connect the park/neutral position switch assembly connector.

  2. CONNECT FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY

    B001Y6Y

    1. Connect the shifting rod to the transmission control shaft lever RH with the pin.

    2. Install a new clip.

  3. INSPECT SHIFT LEVER POSITION

    Click here

  4. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY

    Click here

  5. INSTALL FRONT EXHAUST PIPE ASSEMBLY (w/ DPF)

    Click here

  6. INSPECT FOR EXHAUST GAS LEAK