OIL PUMP REASSEMBLY

PROCEDURE


  1. INSTALL FRONT OIL PUMP OIL SEAL


    1. A01X24SE10

      Using SST and a hammer, tap in a new oil seal.

      SST
      09350-30020   ( 09351-32140 )

      Tech Tips

      The oil seal end should be flush with the outer edge of the pump body.

    2. Coat the lip of the oil seal with MP grease.

  2. FIX FRONT OIL PUMP BODY SUB-ASSEMBLY


    1. Place the oil pump body on the torque converter clutch.

  3. INSTALL FRONT OIL PUMP DRIVEN GEAR


    1. A01X8VQ

      Coat the driven gear with ATF.

    2. Install the driven gear to the oil pump body.

  4. INSTALL FRONT OIL PUMP DRIVE GEAR


    1. A01X3I7

      Coat the drive gear with ATF.

    2. Install the drive gear to the oil pump body.

  5. INSTALL FRONT OIL PUMP BODY O-RING


    1. A01X13UE07
      *1 New O-Ring

      Coat a new O-ring with ATF and install it to the oil pump body.

  6. INSTALL STATOR SHAFT ASSEMBLY


    1. A01X1ON

      Align the stator shaft with the bolt holes.

    2. Install the 14 bolts.

      Torque:
      11 N*m  { 112 kgf*cm, 8 ft.*lbf }

  7. INSTALL CLUTCH DRUM OIL SEAL RING


    1. A01XBCBE17
      *a New Oil Seal Ring

      Coat 3 new oil seal rings with ATF.

    2. Squeeze the ends of the 3 oil seal rings together with an overlap distance of 8 mm (0.314 in.) or less, and then install them to the starter shaft groove.

      Note

      Do not excessively widen the ring.

      Tech Tips

      After installing the oil seal rings, check that they rotate smoothly.

  8. INSPECT OIL PUMP DRIVE GEAR ROTATION

    Click here

  9. INSTALL AUTOMATIC TRANSMISSION CASE O-RING


    1. A01X1I6E06
      *1 New O-Ring

      Coat a new O-ring with ATF and install it to the oil pump assembly.