PARK / NEUTRAL POSITION SWITCH INSTALLATION

PROCEDURE


  1. INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY

    Tech Tips

    Make sure that the manual valve lever shaft has not been rotated prior to installing the park/neutral position switch as the detent spring may become detached from the manual valve lever shaft.


    1. Install the switch to the manual valve shaft.

    2. A01X9CB

      Temporarily install the bolt.

    3. A01WZEEE06
      *1 New Lock Washer

      Install a new lock washer and the nut.

      Torque:
      6.9 N*m  { 70 kgf*cm, 61 in.*lbf }
    4. A01WZIV

      Temporarily install the control shaft lever RH.

    5. A01X7EHE03

      Turn the control shaft lever RH counterclockwise until it stops, and then turn it clockwise 2 notches to set it to the N position.

    6. Remove the control shaft lever RH.

    7. A01X2QRE03
      *1 Neutral Basic Line
      *2 Groove

      Align the groove with the neutral basic line.

    8. Hold the switch in position and tighten the bolt.

      Torque:
      13 N*m  { 133 kgf*cm, 10 ft.*lbf }
    9. A01X5JC

      Using a screwdriver, bend the tabs of the lock washer.

    10. Install the transmission control rod bush and collar to the transmission control shaft lever RH.

    11. A01WZIV

      Install the transmission control shaft lever RH with the spring washer and nut.

      Torque:
      16 N*m  { 163 kgf*cm, 12 ft.*lbf }

    12. Connect the switch connector.

  2. CONNECT FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY

    B001Y6Y

    1. Connect the shifting rod to the transmission control shaft lever RH with the pin.

    2. Install a new clip.

  3. INSPECT SHIFT LEVER POSITION

    Click here

  4. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY

    Click here